Product Name: HFCQ Series Air Gripper Product Model: HFCQ16E HFCQ20E HFCQ25E HFCQ32E HFCQ40E HFCQ50E HFCQ63E HFCQ16V HFCQ20V HFCQ25V HFCQ32V HFCQ40V HFCQ50V HFCQ63V Valve Type: Air Gripper Brand: AirTAC Fluid: Air Acting Type: Double Acting
Specification：
| Bore size: | 16 | 20 | 25 | 32 | 40 | 50 | 63 |
| Acting type: | Double Acting | ||||||
|
Fluid: |
Air(to be filtered by 40μm filter element) | ||||||
| Operating Pressure: | 0.2~0.7MPa(28~100psi)(2.0~7.0bar) | 0.15~0.7MPa(22~100psi)(1.5~7.0bar) | |||||
| Temperature（℃）: | -20~70 | ||||||
| Repeatability mm: | ±0.01 | ||||||
| Lubrication: | Not Required | ||||||
| Max Frequency: | 120(c.p.m) | 60(c.p.m) | |||||
| Sensor Switches: | CMSH、DMSH(S) | ||||||
| Port Size: | M3X0.5 | M5X0.8 | |||||
| Hollow diameter: | ∅3(+0~+0.04) | ∅3(+0~+0.04) | ∅4(+0~+0.04) | ∅6(+0~+0.04) | ∅10(+0~+0.068) | ∅12(+0~+0.07) | ∅3(+0~+0.07) |
| Push rod mechanism: |
- |
Cylinder or Spring push rod mechanism |
|||||
| Port Size of push rod mechanism: | - | M5X0.8 | |||||
1. The hollow tube can be matched with mechanism to achieve the blowing effect.
2. The jaws and piston rods are made of high-grade stainless steel, which has high strength, corrosion resistance and small assembly cleearance, low shaking and high durability.
3. All series are equipped with a dust jacket, which can also be used in special occasions.
4. A positioning hole is attached to the bottom of the body, which can improve the precision and the consistency of repeated dismounting and positioning.
5. The tail end is equipped with a push rod mechanism for the push function.
6. The sensor grooves of each specification are shaed.
Installation & Usage:
1. Due to the abrupt changes, the circuit pressure is low, which will lead to the decrease of the gripping force and falling of the work-pieces. In order to avoid the harm to the human body and damage to the equipment, anti-dropping device must be equipped.
2. Don't use the air gripper under strong external force and impact force.
3. When install and fix the air gripper, avoid falling down, collision and damage.
4. When fixing the gripping jaw parts, don't twist the gripping jaw.
5. There are several kinds of installation method, and the locking torgue of fastening screw must be within the prescribed torque range shown in the below chart. If the locking torque is too large, it will cause the dysfunctional. If the locking torque is too small, it will cause the position deviation and fall.
